|
 |
 |
 |
 |
Works, but needed some adjustment |
May 10, 2017 |
Reviewer:
JR-15 from Apple Valley, MN United States
|
|
The screws attached were too short. Came supplied with two additional, longer screws but the attached were impossible to remove, without some "cutting" as suggested in a prior review. I achieved this by using a Dremel tool to grind down just enough to remove the attached screws and replace with the extras supplied. Appears to work fine now but be careful not to tighten too much, as it will bend the aluminum inside the handguard. In hindsight, may have been better to go with a rail and another grip but if you have already purchased or are just stubborn like me, improvise and you can persevere!
Was this review helpful to you?
|
 |
 |
 |
 |
|